Philips AEA2700 manual

View a manual of the Philips AEA2700 below. All manuals on ManualsCat.com can be viewed completely free of charge. By using the 'Select a language' button, you can choose the language of the manual you want to view.

  • Brand: Philips
  • Product: AV extender
  • Model/name: AEA2700
  • Filetype: PDF
  • Available languages: French, German, Czech, Slovak, English, Italian, Dutch, Hungarian, Polish

Table of Contents

Page: 0
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
AEA2700
Question?
Contact
Philips
Page: 2
1
EN
Contents
1	Safety	 2
2	 Your Bluetooth Adapter	 3
Introduction	3
What's in the box	 3
3	 Before use	 4
Connect audio cables	 4
Connect power	 5
4	 Use the Bluetooth adapter	 6
Connect a Bluetooth device	 6
Disconnect a device	 7
Reconnect a device	 7
Clear pairing history	 7
5	 Product information	 8
Amplifier	 8
Bluetooth	8
General information	 8
6	Troubleshooting	 9
General	9
About Bluetooth device	 9
7	Notice	 10
Compliance	10
Care of the environment	 10
Trademark notice	 10
Copyright	11
Page: 3
2 EN
1	Safety
Read these instructions.
Follow all instructions.
Do not use this apparatus near water.
Do not place near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
Protect the power cord from being walked on
or pinched, particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
Only use attachments/accessories specified by
the manufacturer.
Use only power supplies listed in the user
manual.
The product shall not be exposed to dripping
or splashing.
Do not place any sources of danger on the
product (e.g. liquid filled objects, lighted
candles).
Where the plug of the Direct Plug-in Adapter
is used as the disconnect device, the disconnect
device shall remain readily operable.
Warning
•
• Never remove the casing of this apparatus.
•
• Never lubricate any part of this apparatus.
•
• Never place this apparatus on other electrical
equipment.
•
• Keep this apparatus away from direct sunlight, naked
flames or heat.
•
• Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect the apparatus from
the power.
Page: 4
3
EN
2	 Your Bluetooth
Adapter
Congratulations on your purchase and welcome
to Philips!To fully benefit from the support that
Philips offers, register your product at www.
philips.com.
 
If you contact the Consumer Care, you will
be asked for the model and serial number of
this apparatus.The model number and serial
number are on the bottom of the product.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Introduction
By connecting the Bluetooth adapter to your
Hi-Fi speaker system, you can enjoy audio from
your Bluetooth-enabled device on your Hi-Fi
system through Bluetooth wireless connection.
What's in the box
Check and identify the contents of your
package:
•	 Main unit
•	 Safety sheet
•	 Short user manual
•	 AC power adapter
•	 RCA audio cable
AJ1003
Short User Manual
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
Page: 5
4 EN
3	 Before use
Always follow the instructions in this chapter in
sequence.
Connect audio cables
There are three ways to connect the Bluetooth
adapter to your Hi-Fi system. Select one fit for
the Hi-Fi system.
Option 1: Connect through the AUX
OUT socket
Connect the RCA audio cable between
•	 the AUX OUT socket on the Bluetooth
adapter, and
•	 the analogue audio input sockets on your
Hi-Fi system.
Option 2: Connect through the
COAXIAL OUT socket
L R
Connect a coaxial audio cable between
•	 the COAXIAL OUT socket on the
Bluetooth adapter, and
•	 the coaxial audio input socket on your
Hi-Fi system.
Note
•
• Make sure that no cable is plugged in the AUX OUT
socket.
Option 3: Connect through the
OPTICAL OUT socket
Connect an optical audio cable between
•	 the OPTICAL OUT socket on the
Bluetooth adapter, and
•	 the optical audio input sockets on your
Hi-Fi system.
Note
•
• Make sure that no cable is plugged in the AUX OUT
socket.
OPTICAL OUT
Page: 6
5
EN
Connect power
Caution
•
• Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the
bottom of the unit.
•
• Risk of electric shock! Hold the plug securely when
unplugging the device.
Note
•
• The type plate is located on the bottom of the
Bluetooth adaptor.
Connect the power adaptor to:
•	 the DC IN socket at the back of the
Bluetooth adapter.
•	 the wall outlet.
Page: 7
6 EN
4	 Use the
Bluetooth
adapter
Connect the Bluetooth adapter to your Hi-Fi
system with audio cable, and then you can
stream audio from your Bluetooth device to the
Hi-Fi system via Bluetooth.
Connect a Bluetooth device
Note
•
• WOOX Innovations does not guarantee the
compatibility with all Bluetooth devices.
•
• Before pairing a device with this product, read its user
manual for Bluetooth compatibility. Make sure that the
connected Bluetooth device supports the Advanced
Audio Distribution Profile (A2DP) and the AudioVideo
Remote Control Profile (AVRCP).
•
• The product can connect a maximum of 3 Bluetooth
devices simultaneously.
•
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
•
• The operational range between this product and a
Bluetooth device is approximately 10 meters (33 feet).
•
• Any obstacle between this product and a Bluetooth
device can reduce the operational range.
•
• Keep away from any other electronic device that may
cause interference.
Bluetooth indicator
The LED Bluetooth indicator in the button
indicates the status of Bluetooth connection.
Indicator Bluetooth connection
Blinking blue in
1 Hz
Connecting with a paired
device
Blinking blue in
4 Hz
Waiting for pairing
Solid blue Connected
Dim light Disconnected
Enter Bluetooth pairing mode
•	 When connected to power, the Bluetooth
adapter tries to connect with the last
paired device. If no device is paired, the
Bluetooth adapter enters Bluetooth pairing
mode automatically.
•	 Afterwards press and hold for 2 seconds
to enter Bluetooth pairing mode.
Note
•
• If Bluetooth pairing fails in 15 minutes, the Bluetooth
adapter exits the pairing mode.
Connect manually
1	 Press and hold for 2 seconds to switch
this Bluetooth adapter to pairing mode.
»
» The Bluetooth indicator in the button
blinks in 4 Hz.
2	 On your Bluetooth device, enable the
Bluetooth feature and search for devices.
3	 In the device list, select PHILIPS AEA2700.
•	 If a message prompts for the
permission for Bluetooth connection
with PHILIPS AEA2700, confirm it.
•	 If a password is required, enter 0000
and then confirm.
Connect easily by NFC
If your Bluetooth device supports NFC (Near
Field Communication), you can connect it with
this product easily.
1	 On your device, enable NFC and
Bluetooth functions.
2	 Tap the back of your Bluetooth device at
the NFC tag on this product.
3	 On your Bluetooth device, follow the on-
screen instructions to complete the pairing
and connection.
Page: 8
7
EN
Connect a fourth Bluetooth device
•	 Connect the fourth device manually (see
'Connect manually' on page 6).
•	 Press and hold for 2 seconds to switch
AEA2700 to pairing mode, and then
connect the fourth Bluetooth device by
NFC (see 'Connect easily by NFC' on
page 6).
»
» Once the fourth device is connected,
the earliest connected device will be
replaced, if there is no music play.
Disconnect a device
•	 On your device, disable the Bluetooth
connection with this product.
•	 If the Bluetooth connection is activated
by NFC, tap the back of your Bluetooth
device at the NFC tag on this product.
Reconnect a device
•	 For a paired Bluetooth device on which
the automatic reconnection is enabled,
this product reconnects with it once it is
detected.
•	 For a paired Bluetooth device that does
not support the automatic reconnection,
reconnect it with this product manually.
Clear pairing history
Press and hold for 5 seconds.
»
» The connected speaker beeps three
times.
Page: 9
8 EN
5	Product
information
Note
•
• Product information is subject to change without prior
notice.
Amplifier
OutputVoltage 1000 mV RMS
Frequency Response 20 Hz - 20 kHz,
±3 dB
Signal to Noise Ratio > 62 dB
Total Harmonic Distortion < 1 %
Bluetooth
Standard Bluetooth StandardVersion 3.0
Frequency
Band
2.402~2.480 GHzISM Band
Range 10m (free space)
General information
AC Power Model:AS030-090-
EE033 / EML0900330V
(Philips)
Input: 100-240V ~,
50/60 Hz, 0.15 A
Output: 9V 0.33 A
Operation Power
Consumption
< 3 W
Standby Power
Consumption
< 0.5 W
Dimensions - Main
Unit
(W x H x D) 74 x 28 x 72 mm
Weight - Main Unit 0.04 kg
Page: 10
9
EN
6	Troubleshooting
Warning
•
• Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support).When you contact the
Consumer Care, make sure that the product
is nearby and the model number and serial
number are available.
General
No power
•
• Make sure that the AC power adapter is
connected properly.
•
• Make sure that there is power at the AC
outlet.
No sound from your Hi-Fi system
•
• Check if the Hi-Fi system is connected to
power.
•
• Make sure that the system is connected
with the Bluetooth adapter properly.
•
• Make sure that the Bluetooth wireless
connection is successful.
•
• Adjust the volume of your system and
Bluetooth device.
•
• Make sure that the Hi-Fi system is in
Audio-in or line-in mode.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•
• The Bluetooth reception is poor. Move the
device closer to the Bluetooth adaptor or
remove any obstacle between the device
and the adaptor.
Cannot connect with the device.
•
• The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•
• The adapter is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects
constantly.
•
• The Bluetooth reception is poor. Move the
device closer to the Bluetooth adapter or
remove any obstacle between the device
and the adapter.
•
• For some devices, the Bluetooth
connection may be deactivated
automatically as a power-saving feature.
This does not indicate any malfunction of
the system.
Page: 11
10 EN
7	Notice
Any changes or modifications made to this
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Compliance
This product complies with the radio
interference requirements of the European
Community.
Hereby,WOOX Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
of Directive 1999/5/EC.You can find the
Declaration of Conformity on www.philips.com/
support.
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU. Inform yourself about the local
separate collection system for electrical and
electronic products.
Follow local rules and never dispose of the
product with normal household waste. Correct
disposal of old products helps prevent negative
consequences for the environment and human
health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.
The N Mark is a trademark or registered
trademark of NFC Forum, Inc. in the United
States and in other countries.
Page: 12
11
EN
Copyright
2014 © WOOX Innovations Limited.All rights
reserved.
Philips and the Philips’ Shield Emblem are
registered trademarks of Koninklijke Philips N.V.
and are used by WOOX Innovations Limited
under license from Koninklijke Philips N.V.”
Specifications are subject to change without
notice.WOOX reserves the right to change
products at any time without being obliged to
adjust earlier supplies accordingly.
Page: 13
Specifications are subject to change without notice.
2014 © WOOX Innovations Limited.All rights reserved.
This product was brought to the market by WOOX Innovations Limited or one of
its affiliates, further referred to in this document as WOOX Innovations, and is the
manufacturer of the product.WOOX Innovations is the warrantor in relation to the
product with which this booklet was packaged. Philips and the Philips Shield Emblem
are registered trademarks of Koninklijke Philips N.V.
AEA2700_12_UM_V1.0

Question & answers

There are no questions about the Philips AEA2700 yet.

Ask a question about the Philips AEA2700

Have a question about the Philips AEA2700 but cannot find the answer in the user manual? Perhaps the users of ManualsCat.com can help you answer your question. By filling in the form below, your question will appear below the manual of the Philips AEA2700. Please make sure that you describe your difficulty with the Philips AEA2700 as precisely as you can. The more precies your question is, the higher the chances of quickly receiving an answer from another user. You will automatically be sent an e-mail to inform you when someone has reacted to your question.