Panasonic EY0L81 manual

View a manual of the Panasonic EY0L81 below. All manuals on can be viewed completely free of charge. By using the 'Select a language' button, you can choose the language of the manual you want to view.

  • Brand: Panasonic
  • Product: Battery charger
  • Model/name: EY0L81
  • Filetype: PDF
  • Available languages: English, French, Spanish, Dutch, German, Italian, Swedish, Danish, Russian, Norwegian, Finnish, Romanian, Ukrainian

Table of Contents

Page: 2
-  -
	 Read All Instructions
-This manual contains important
safety and operating instructions
for battery charger EY0L81.
	2)	 Before using battery charger, read
all instructions and cautionary
markings on battery charger, bat-
tery pack, and product using battery
	 3)	 CAUTION -To reduce the risk of in-
jury, charge only Panasonic Battery
pack as shown in last page. Other
types of batteries may burst causing
personal injury and damage.
	 4)	 Do not expose charger and battery
pack to rain or snow or use in damp
	 5)	 To reduce risk of damaging the
electric plug and cord, pull by plug
rather than cord when disconnect-
ing charger.
	 6)	 Make sure cord is located so that it
will not be stepped on, tripped over,
or otherwise subjected to damage
or stress.
	 7)	 An extension cord should not be
used unless absolutely necessary.
		 Use of improper extension cord
could result in a risk of fire and
electric shock. If extension cord
must be used, make sure that:
pins on plug of extension cord are
the same number, size and shape
as those of plug on charger.
extension cord is properly wired
and in good electrical condition.
c.	wire size is large enough for
ampere rating of charger as
specified below.
AC Input Rating. Amperes AWG Size of Cord
Equal to or
greater than
But less
Length of Cord, Feet
25 50 100 150
0 2 18 18 18 16
	 8)	 Do not operate charger with dam-
aged cord or plug — replace them
	 9)	 Do not operate charger if it has re-
ceived a sharp blow, been dropped,
or otherwise damaged in any way;
take it to a qualified service agent.
	 10)	 Do not disassemble charger; take
it to a qualified service agent when
service or repair is required. Incor-
rect reassembly may result in a risk
of electric shock or fire.
	 11)	 To reduce risk of electric shock,
unplug charger from outlet before
attempting any maintenance or
	 12)	 The charger and battery pack are
specifically designed to work to-
gether. Do not attempt to charge
any other cordless tool or battery
pack with this charger.
	 13)	 Do not attempt to charge the bat-
tery pack with any other charger.
	 14)	 Do not attempt to disassemble the
battery charger and the battery
pack housing.
	 15)	 Do not store battery pack in loca-
tions where the temperature may
reach or exceed 50°C (122°F)
(such as a metal tool shed, or a car
in the summer), which can lead to
deterioration of the storage battery.
	 16)	 Do not charge battery pack when
the temperature is BELOW 0°C
(32°F) or ABOVE 40°C (104°F).
This is very important.
	 17)	 Do not incinerate the battery pack.
It can be explode in a fire.
	 18)	 Avoid dangerous environment. Do
not use charger in damp or wet lo-
	 19)	 The charger is designed to oper-
ate on standard household elec-
trical power only. Charge only on
the voltage indicated on the name-
plate. Do not attempt to use it on
any other voltage!
	20)	 Do not abuse cord. Never carry
charg­er by cord or yank it to discon-
nect from outlet. Keep cord away
from heat, oil and sharp edges.
Page: 3
-  -
	21)	 Charge the battery pack in a well
ventilated place, do not cover the
charger and battery pack with a
cloth, etc., while charging.
	22)	 Use of an attachment not recom-
mended may result in a risk of fire,
electric shock, or injury to persons.
	23)	 Do not short the battery pack. A
battery short can cause a large cur-
rent flow, over heating and burns.
	24)	 NOTE: If the supply cord of this ap-
pliance is damaged, it must only be
replaced by a repair shop appoint-
ed by the manufacturer, because
special purpose tools are required.
		 This plug will fit in a polarized out-
let only one way. If the plug does
not fit fully in the outlet, reverse the
plug. If it still does not fit, contact
a qualified electrician to install the
proper outlet. Do not change the
plug in any way.
Common Cautions
•	When charging a cool battery
pack (below 0°C (32°F)) in a warm
place, leave the battery pack at the
place and wait for more than one
hour to warm up the battery to the
level of the ambient temperature.
Otherwise battery pack may not be
fully charged.
•	Cool down the charger when charging
more than two battery packs consecu-
•	Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
To prevent the risk of fire or damage
to the battery charger.
•	Do not use power source from an
engine generator.
•	Do not cover vent holes on the
charger and the battery pack.
•	Unplug the charger when not in
Your battery pack is not fully charg­
ed at the time of purchase. Be sure
to charge the battery before use.
Battery charger
1.	 Plug the charger into the AC outlet.
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
2.	 Insert the battery pack firmly into the
1)	 Line up the alignment marks and
place the battery onto the dock on
the charger.
2)	 Slide forward in the direction of the
Alignment marks
3.	 During charging, the charging lamp will
be lit.
When charging is completed, an inter-
nal electronic switch will automatically
be triggered to prevent overcharging.
•	 Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
	 The orange standby lamp will be
flashing until the battery cools down.
	 Charging will then begin automati-
4.	 The charge lamp (green) will flash
slowly once the battery is approxi­mate­
ly 80% charged.
Page: 4
-  -
5.	 When charging is completed, the
charging lamp in green color will turn
6.	 If the temperature of the battery pack
is 0°C or less, charging takes longer
to fully charge the battery pack than
the standard charging time.
	 Even when the battery is fully charg­
ed, it will have approximately 50% of
the power of a fully charged battery at
normal operating temperature.
7.	 Consult an authorized dealer if the
charging lamp (green) does not turn
8.	 If a fully charged battery pack is insert­
ed into the charger again, the charg-
ing lamp lights up. After several min-
utes, the charging lamp in green color
will turn off.
Page: 5
-  -
Charging is completed. (Full charge.)
Battery is approximately 80% charged.
Now charging.
Charger is plugged into the AC outlet. Ready to charge.
(Green) (Orange) Charging Status Lamp.
Left: green Right: orange will be displayed.
Battery pack is cool.
The battery pack is being charged slowly to reduce the load on the battery.
Battery pack is warm.
Charging will begin when temperature of battery pack drops. If the temperature of the
battery pack is -10° or less, the charging status lamp (orange) will also start flashing .
Charging will begin when the temperature of the battery pack goes up"
Charging is not possible. Clogged with dust or malfunction of the bat-
tery pack.
Turn off	 Lit	 Flashing
Model EY0L81
Electrical rating See the rating plate on the bottom of the charger.
Weight 0.93 kg (2 lbs.)
[Li-ion battery pack]
10.8 V 14.4 V
EYFB30 EY9L41 EY9L42
Charging time
Usable: 40 min.
Full: 65 min.
Usable: 45 min.
Full: 60 min.
Usable: 30 min.
Full: 35 min.
21.6 V 28.8 V
EY9L61 EY9L81
Charging time
Usable: 55 min.
Full: 70 min.
Usable: 65 min.
Full: 80 min.
Page: 6
-  -
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful in-
terference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
•	Reorient or relocate the receiving antenna.
•	Increase the separation between the equipment and receiver.
•	Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•	Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, install and use in accordance with
provided instructions. Use only the battery pack specified in the instructions. Any
changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Page: 19
One Panasonic Way, Secaucus, New Jersey 07094
No.2 EN, FR, ES
EY98100L811 2010 08	 Printed in China

Question & answers

There are no questions about the Panasonic EY0L81 yet.

Ask a question about the Panasonic EY0L81

Have a question about the Panasonic EY0L81 but cannot find the answer in the user manual? Perhaps the users of can help you answer your question. By filling in the form below, your question will appear below the manual of the Panasonic EY0L81. Please make sure that you describe your difficulty with the Panasonic EY0L81 as precisely as you can. The more precies your question is, the higher the chances of quickly receiving an answer from another user. You will automatically be sent an e-mail to inform you when someone has reacted to your question.