Panasonic ER-CA35-K manual

View a manual of the Panasonic ER-CA35-K below. All manuals on ManualsCat.com can be viewed completely free of charge. By using the 'Select a language' button, you can choose the language of the manual you want to view.

  • Brand: Panasonic
  • Product: Beard Trimmer
  • Model/name: ER-CA35-K
  • Filetype: PDF
  • Available languages: English, French, Spanish

Table of Contents

Page: 1

English
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic
precautions are required to always be followed,
including the following:
Read all instructions before using this appliance.
DANGER	To reduce the risk of electric
shock:
1.	Do not reach for an appliance that has fallen
into water. Unplug immediately.
2.	Do not use while bathing or in a shower.
3.	Do not place or store appliance where it is able
to fall or be pulled into a tub or sink. Do not
place in or drop into water or other liquid.
4.	Except when charging, always unplug this
appliance from the electrical outlet immediately
after using.
5.	Unplug this appliance before cleaning.
WARNING	To reduce the risk of burns, fire,
electric shock, or injury to persons:
1.	Close supervision is required when this
appliance is used by, on, or near children or
invalids.
2.	Use this appliance only for its intended use as
described in this manual. Do not use
attachments not specified by the manufacturer.
3.	Never operate this appliance when it has a
damaged cord or plug, when it is not working
properly, after it has been dropped or damaged,
or after it has been dropped into water. Return
the appliance to a service center for
examination and repair.
4.	Keep the cord away from heated surfaces.
5.	Never drop or insert any object into any
opening.
6.	Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
7.	Do not use this appliance with a damaged or
broken comb, as it has the potential to result in
facial injury.
8.	Always attach plug to appliance first, then to
outlet. To disconnect, turn all controls to “off”
then remove plug from outlet.
SAVETHESE INSTRUCTIONS
Specifications
Power source: 
See the name plate on the product.
(Automatic voltage conversion)
Motor voltage: 1.2 V DC
Charging time: 8 hours
This product is intended for household use only.
Page: 2
English
	
Safety instructions
Failure to observe the Safety instructions may result in death,
serious injury, electric shock, fire or short circuit.
Be careful when treating the AC adaptor
Disconnect the AC adaptor from the outlet when cleaning the
clipper.
Always grip the AC adaptor and not the power cord.
Do not use the clipper if the power cord or the AC adaptor is
worn, or if the AC adaptor does not fit snugly in the outlet.
Do not damage or deform the power cord. Do not place heavy
objects on the power cord or trap it between objects.
Clean the power plug regularly to remove any dust or dirt.
The power cord cannot be replaced. If it is damaged, the AC
adaptor should be discarded.
Keep out of liquid
Do not use the clipper with AC operation in bathrooms.
Do not insert and remove the AC adaptor with wet hands.
Do not allow the AC adaptor to get wet.
Do not wipe the clipper or AC adaptor with thinner, benzine or
alcohol.
Failure to observe the following may result in injuries to
the skin
Do not press the blade against the skin.
Do not use the clipper for any purpose other than trimming.
Do not trim the hair of a pet.
Check that the blades are not damaged or deformed before use.
Before using each time, apply oil at the places marked with
arrows. (See page 6.)
Caution for charge
Charging for longer than 48 hours may shorten the life of the
battery.
The clipper may become warm during operation and/or charging.
This is normal.
►
•
‑
•
•
•
•
►
•
•
•
•
►
•
•
•
•
•
►
•
•
Charge the clipper at temperatures between 5 °C (41 °F) and
35 °C (95 °F) to work correctly.
Do not use any power cord or AC adaptor other than one
specifically designed for this model. (RE9‑45)
The adaptor is intended to be correctly oriented in a vertical or
floor mount position.
Caution for usage and storage
Do not disassemble or modify the clipper. Do not attempt repairs.
Repairs must always be requested to your dealer.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
This clipper is for indoor use only.
Do not store the clipper in a place exposed to direct sunlight or
near a heater or other source of heat.
•
•
•
►
•
‑
•
•
•
Page: 3

English The charging time is 8 hours.
1 full charge will provide approximately 40 minutes of continuous
operation.
If the shape of the plug does not fit the power outlet, use an
attachment plug adaptor of the proper configuration.
Inserting the attachment
0.8" / 1.2" / 1.6" (20/30/40mm) comb attachment
1.	Adjust the attachment to the desired
trimming height by sliding it until it
clicks while the switch is in
“0•CHARGE”.
Set the attachment to the correct position.
Otherwise you cannot set the switch to “1”.
Actual hair length will be a little longer than
the height you set.
•
•
1/8" / 1/4" (3/6mm), 3/8" / 1/2" (9/12mm) comb
attachments
1/4"
1/8"
1/8" / 1/4"
3/8"
1/2"
3/8" / 1/2"
1.	Select the
cutting heights
indicated on the
insides and
sides of the
attachments.
2.	Mount the
attachment to
the clipper as
illustrated.
3.	Remove the
attachment
from the clipper.
•
•
•
►
►
Parts identification
A	Blade
B	Attachment mounting
C	Switch
D	Charging indicator lamp
E	1/8" / 1/4" (3/6mm) comb
attachment
F	3/8" / 1/2" (9/12mm) comb
attachment
G	0.8" / 1.2" / 1.6" (20/30/40mm)
comb attachment
H	Lever for cleaning
I	AC adaptor (RE9‑45)
J	Power cord
K	Oil
L	Cleaning brush








3mm
6

20
30
40
mm



Charging
C
h
a
r
g
e
1.	Set the switch
to “0•CHARGE”,
and insert the
power cord into
the clipper.
2.	Connect the AC
adaptor into an
outlet.The
charging
indicator lamp
will light up.
3.	Disconnect the
AC adaptor
from an outlet
when charging
is completed.
Page: 4
English
	
Blade maintenance
C
a
r
e
The following is the symbol for a washable clipper. The
symbol means the hand-held part may be cleaned under
water.
Mounting and removal of the blade
1.	Hold the clipper with the “Panasonic”
mark facing upward and push the blade
with your thumb while catching the
blade in your other hand.
Be sure to set the switch to “0•CHARGE”
before you remove the blade.
•
2.	To remount the blade, fit the mounting
hook into the blade mounting on the
clipper and push in until it clicks.
Blade life
Blade life will vary according to the frequency and length of use. It
is expected to be about 2 years when using the clipper twice a
month for 20 minutes each time. If cutting efficiency is reduced
despite proper maintenance, change the blades.
Battery life
Battery life will vary according to the frequency and length of use.
If the batteries are charged 3 times a month, the service life will be
approximately 3 years.
It is recommended that the clipper be recharged at least every 6
months even when not in regular use because the charge will
drain from the batteries and their service life may be shortened.
►
►
•
Cutting your hair
C
u
t
1 Cut hair to the correct height by
moving the clipper back against the
flow of the hair.
•	Do not use the clipper in an inverted
position. This can cut hair too deeply.
Trimming with no attachments
Cutting without an attachment will trim hair length to 1 mm or less.
1.	Cut hair by placing the clipper head
directly on the scalp.
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and set the switch to “1”, you can use it even if the
battery capacity is low.
If the clipper does not operate, set the switch to “0•CHARGE”,
wait about 1 minute and then set it back to “1”.
Be careful not to discharge the battery completely with the switch
left in “1”. It results in shortening the battery life.
►
►
•
•
Page: 5

English
Cleaning the blade
If washing in water
WARNING: Detach the hand-held part from the supply cord before
cleaning it in water.
1.	Rinse off any hairs
sticking to the blade and
any hairs inside the
clipper.
2.	Shake the clipper 4 or 5
times gently, wipe off any
water drops from the
clipper and blade, and
then let it dry onto a towel
with the “Washable”
indicator facing upward.
If cleaning with brush
1.	Brush off
any hairs
from the
clipper and
from around
the blade.
2.	Remove the
blade and
brush off
the hairs
from the
blade edge.
3.	Brush the hairs out
from between the fixed
blade and the moving
blade while pressing
down on the lever for
cleaning to raise the
moving blade.
►
►
After cleaning the blade with water or brush
1.	Apply a few drops of the oil to the points
indicated by the arrows.
2.	Remount the blade on the clipper.
Apply the oil to the clipper after use. Otherwise
the blades may become dull, make abnormal
noises, or becomes hot and lead to the
deterioration of cutting performance.
•
Removing the built-in rechargeable battery
ATTENTION:
A nickel metal hydride battery that is recyclable powers the
product you have purchased. Please call 1-800-8-BATTERY for
information on how to recycle this battery.
R B R C
N i - M H
T M
WARNING:
Do not attempt to replace the battery for the purpose of reusing
the clipper. This could result in the risk of fire or electric shock.
►
Page: 6
English
	
Remove the battery as illustrated.
	Disconnect the clipper from the AC adaptor when removing the
battery.
	Fully discharge the battery.
	Be careful not to short the + and - terminals of the battery after
removing it.
1.
.
3.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-
FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE
HOT LINE AT 1-800-332-5368.
IN CANADA, CONTACT CANADA INC. AT THE ADDRESS OR
TELEPHONE NUMBER ON THE BACK PAGE.
Page: 19
F. No.1 EN FR SP (U.S.A/CANADA)
Printed in China
Imprimé en Chine
Impresso na China
IN USA CONTACT:
Panasonic Consumer Electronics Company
One Panasonic Way 2F-3 Secaucus, NJ 07094
IN CANADA CONTACT:
AU CANADA, CONTACTER:
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3
(905) 624-5010
En México:
Panasonic de México, S.A de C.V.
México D.F.
Moras No. 313 Col. Tlacoquemecatl del Valle Del. Benito Juarez,
Mexico, D.F, C.P.03200 R.F.C PME-780907754 Tel: 54-88-10-00
Service • Assistance • Accessories
Dépannage • Assistance • Accessoires
Call 1-800-338-0552 (In USA)
http://www.panasonic.com/shavers/	
http://www.panasonic.com/consumersupport/
Call 1-800-561-5505 (In Canada)
Composer 1-800-561-5505 (Au Canada)
http://www.panasonic.ca/

Question & answers

Replacement battery for ER-CA35

Published on 1 month ago by tony

Ask a question about the Panasonic ER-CA35-K

Have a question about the Panasonic ER-CA35-K but cannot find the answer in the user manual? Perhaps the users of ManualsCat.com can help you answer your question. By filling in the form below, your question will appear below the manual of the Panasonic ER-CA35-K. Please make sure that you describe your difficulty with the Panasonic ER-CA35-K as precisely as you can. The more precies your question is, the higher the chances of quickly receiving an answer from another user. You will automatically be sent an e-mail to inform you when someone has reacted to your question.