Argoclima Polifemo Class manual

View a manual of the Argoclima Polifemo Class below. All manuals on ManualsCat.com can be viewed completely free of charge. By using the 'Select a language' button, you can choose the language of the manual you want to view.

  • Brand: Argoclima
  • Product: Air-conditioning
  • Model/name: Polifemo Class
  • Filetype: PDF
  • Available languages: English, Italian

Table of Contents

Page: 0
11
V 12/16
OPERATING INSTRUCTIONS
Read the instructions carefully before operating the appliance or carrying out maintenance operations.
Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage.
Keep these instructions in a safe place for future reference.	
EVAPORATIVE AIR COOLER
EN
Page: 1
12
V 12/16
	
GENERAL SAFETY INFORMATION
 Only use this appliance as described in this manual. Any other
use not recommended by the manufacturer may cause
fire, electric shock or injury to people.
 Make sure that the type of mains power complies with the
electrical requirements of the appliance (220 V~/50 Hz).
 This appliance can be used by children aged from 8 years and
above and people with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
 Children shall not play with the appliance.
 Cleaning and user maintenance shall not be made by children
without supervision.
 This product is not a toy. Children should be adequately
supervised to ensure that they do not play with the appliance.
 Disconnect the mains power when the appliance is not used or for
cleaning operations.
In the event of any problems, switch off the appliance
immediately, do not attempt to repair it, and take it to
your local After-Sales Service Centre.
Do not remove or replace individual parts, as this
could affect product safety.
Do not touch the power cord with wet or damp
hands; risk of electric shock.
Do not insert objects into the appliance grilles.
This could cause leaks, short-circuits and damage to
the product.
Do not spray flammable substances or pesticides
near the product as they could damage it.
Do not disassemble the
appliance! Warning!!! Do not touch
Risk of electric shock!
Warning!!! Do not touch
Risk of electric shock!
Prohibited!
Page: 2
13
V 12/16
Do not use the appliance if the cord or plug is
damaged. Do not attempt to change the power cord
yourself. If the power cord is damaged, it must be
replaced by the manufacturer, dealer or a similarly
qualified person so as to avoid any safety risks.
Do not bend or stand heavy objects on the power
cord.
Turn the switch off and unplug before carrying out
any maintenance work or moving the appliance.
Always unplug from the socket when the appliance is
not in use.
To disconnect the appliance, press the OFF button
and unplug from the socket. Only pull on the plug.
Do not pull the cord. Otherwise the cable may be
damaged or leaks, etc. may occur.
Do not pour water over the product: risk of short-
circuits and damage to the product.
Do not leave the airflow directed towards children
for long periods of time: it is not good for their
health.
Warning!!! Do not touch
Risk of electric shock!
Page: 3
14
V 12/16
DESCRIPTION OF PARTS
1. Button
2. Blade
3. Function display window
4. CD grain decorative sheet
5. Front shell
6. Water level display window
7. Universal casters
8. Handle
9. Remote repository
10. Back shell
11. Air filter
12. Reel
13. Power cord
14. Water tank
15. Casters
16. Tank lock
HOW TO USE THE APPLIANCE
The appliance does not need to be installed.
Position the unit on a flat, stable surface and connect the power cord to a suitable power socket (230 V~): the appliance
can be switched on using the ON/OFF button. The unit can be switched off using the OFF button and you will hear a
sound.
When you move it, use the handle on the back. Do not use this cooler in an area with high humidity, rich in dust or with a
temperature above 40 ° C.
This product can be used either as a fan, with 4 modes (Normal, Natural, Sleep and Smart) and 3 fan speed options (low,
medium and high), or as a cooler/humidifier: in this case the rear tank should be filled with demineralized water, up to but
not exceeding the maximum level as indicated. When the water in the tank falls below the minimum level, marked on the
tank, the appliance emits a continuous sound for a few seconds to signal a low water level, then cooling mode is stopped.
The unit automatically shuts down when the tank is removed.
The fan takes in air from the room and passes it through the dust filter and the evaporative panel, which is constantly
humidified thanks to a system which draws water from the tank and sprays it onto the panel. The incoming hot air makes
part of the water contained in the panel evaporate and is therefore cooler when released back into the room, which makes
it feel as though the temperature has dropped.
Page: 4
15
V 12/16
DISPLAY AND CONTROL PANEL
ON/OFF SPEED SWING TIMER COOLER/HUMIDIFIER MODE
1. Low speed
2. Medium speed
3. High speed
4. Swing blade
5. Function not available
6. Cooler/humidifier
7. Sleep mode
8. Natural sleep
9. Smart mode
Page: 5
16
V 12/16
ON/OFF BUTTON
In power on state, press this button, the unit turns off and enters standby mode.
In power off state, press this button and all LED lights flash sequentially clockwise; then it enters default working state,
except the Timing, Sleep and Natural mode.
REMOTE CONTROL
Page: 6
17
V 12/16
Below is default working states:
MODE BUTTON
In power on state, press this button to switch the working mode among Normal, Natural, Sleep e Smart.
- Normal mode: the unit runs at a constant speed setting;
- Natural mode: the unit runs at changing wind speed; in natural wind state, LED only displays the set level, which
doesn’t change with the wind speed, same as natural wind.
Sleep mode: the unit runs at natural wind, decreasing by one level every 30 minutes; in sleep wind mode, LED only
displays the set level, which doesn’t change with the wind speed, same as natural wind.
- High speed: the unit works for 30 minutes at high speed in natural mode, 30 minutes at medium speed in natural
mode and keep working at low speed always in natural mode.
-
- Medium speed: the unit works for 30 minutes at medium speed in natural mode and keep working at low speed
always in natural mode.
- Low speed: the unit works at low speed in natural mode.
Smart mode:
The specific functions of smart mode are as follows: When the ambient temperature is below 25°C, the unit runs at low
speed wind; when the ambient temperature is 25-29°C, the unit runs at medium speed wind; when the ambient
temperature is above 29°C, the unit runs at high speed wind. Meanwhile, when the smart mode is turned on, the ambient
temperature digital tube and the smart mode indicator and the wind speed indicator flash three times simultaneously to
prompt that smart mode is enabled, and the corresponding wind speed indicator turns on; you can press the Speed button
to cancel the smart mode and return to normal wind.
COOLING/HUMIDIFY BUTTON
Press this button to turn on or turn off the "Cooler/Humidifier" mode: the LED lights up.
SPEED BUTTON
In power state, press the SPEED button to switch among low , medium and high level.
SWING BUTTON
In power state, press this button to switch on/off the rotary blades; the corresponding indicator displays its function. The
blades rotate 360° clockwise or counter-clockwise.
Press and hold the “Swing” button and “Timer” button simultaneously for 3 seconds to cancel the sound; press and hold
the two buttons again to turn on the sound.
Page: 7
18
V 12/16
TIMING BUTTON
a. After turning on, the timer indicator is turned off by default and the digital tube displays ambient temperature; when the
button is first pressed, the timer sets to 30 minutes; the time increases by 30 minutes when the button is pressed every
time, and the timer can be set up to 8 hours; if the button is pressed again, the digital tube displays 00, and the timer
turns off; press the button again to repeat the cycle;
b. After setting the time, the digital tube displays the ambient temperature, and "C "indicator turns on. During the last 30
minutes, the digital tube displays remaining time and enters standby state after reaching specified time.
PROTECTION FUNCTIONS
- Water pump protection
When the software detects water shortage for few seconds, the cooling function stops working, the ventilation function
keeps going on and the buzzer sends bibi alarm sound.
Press the Cooling/Humidify button for three times within three seconds after power on. Take out the tank and fill it as
described in the section "Filling the water tank".
- Water tank extraction protection
When the water tank is extracted, the machine power is cut off and the buzzer sends BiBi sound and it stops working.
When the water tank is put back, the buzzer sends BiBi sound, and the power enters standby mode.
- Smart memory for unexpected power outage
When the power is restored after unexpected power outage, the appliance sends "bi" sound; after 30 seconds, it resumes
the previous state and all functions are restored.
- Auto power-off function
If the device has been running for 15 hours continuously in default state after power on and there is no operation, it
automatically turns off. If you want to cancel this function, press and hold the Cooling and the Mode button for 3 seconds
simultaneously; the buzzer sends Bi sound and cancels auto power-off function; press and hold the two buttons again, the
buzzer sends Bi sound and resumes auto power-off function.
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below)
Open the battery cover on the back of the remote control (press and pull the cover).
Place the battery inside the cover, making sure the polarity is correct.
Slot the cover back into position on the remote control.
Use Lithium/Manganese button cells, model no. CR2032 -3 V, compliant with Battery Directive no. 2006/66/EC (supplied
with the remote control).
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE
2006/66/EC
Please replace the battery when its electrical charge has been exhausted: at the end of its useful life, it must not be disposed of
together with unsorted waste. It must be must be delivered to appropriate separated waste disposal plants or to dealers that
provide a similar service. Separate waste disposal of batteries prevents potential negative effects on the environment and human
health resulting from inadequate disposal, and also allows the materials from which it is made to be recovered and recycled in
order to achieve significant savings in terms of energy and resources. The separate disposal obligation is underlined by the
crossed-out dustbin symbol appearing on the battery. Illegal disposal of the product by the user shall result in the application of
administrative sanctions as defined by current regulations.
Page: 8
19
V 12/16
THE TANK MUST BE FILLED WITH DEMINERALIZED WATER FOR THE APPLIANCE TO
OPERATE IN COOLER/HUMIDIFIER MODE.
Counter-rotate the tank knob by 90° and remove it from its slot; fill it with demineralized water, up to the maximum level mark.
Reposition the tank and turn the knob.
If you wish to keep the water in the tank below room temperature in order to maximise cooling in warmer months, leave one of
the two synthetic ice packs supplied in the freezer until solid, then add it to the water in the tank.
The ice will absorb heat from the water.
We recommend continuous use of the ice for optimal cooling capacity.
The first time it is used, you may detect a smell or the water may turn an unusual colour: this does
not consititute a health risk.
MAINTENANCE AND STORAGE
WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE
PROCEDURES.
IMPORTANT: DO NOT SUBMERGE THE PRODUCT IN WATER
Cleaning the outside surface of the appliance
Use a soft cloth to remove any dust from the product.
If this is not enough, use a soft cloth dampened with water and a mild detergent at a temperature not exceeding 50°C. Let the
appliance dry completely before using it.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical
substances or other items that may damage the surface to clean it.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
Cleaning the dust filter, the cooling panel and the tank
Clean the dust filter frequently, at least once a month.
Remove the dust filter by pulling the knob on the cooling panel, as indicated in the diagram below.
FILLING THE WATER TANK
Water tank
unlocked
Water tank
locked
Water tank
pulled out
Filling water
Page: 9
20
V 12/16
.
STORAGE
If the appliance is not used for prolonged periods, disconnect the power cord and store the appliance with this manual in its
original packaging, in a cool and dry place.
Before packaging, the honeycomb filter and dust-proof filter should be dry, and there is no water in the tank.
INFORMATION FOR THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH
EUROPEAN DIRECTIVE 2012/19/EU
This appliance may not be scrapped with domestic waste at the end of its life cycle. We call your attention to the crucial role
played by the consumer in the re-use, recycling and other forms of recovery of such waste.
The appliance must be scrapped by a sorted waste disposal centre or by returning it to the retailer (no charge is levied for this
service), when you purchase a new equivalent appliance.
Sorted disposal of electric and electronic equipment prevents the negative effects on the environment and human health
resulting from improper scrapping, and also allows the materials from which it is made to be recovered and recycled, with
significant savings in terms of energy and resources. The sorted disposal requirement is indicated by the crossed waste bin
label affixed to the appliance.
Clean the dust filter using a soft brush or a vacuum cleaner, and wash it in a solution of
water and mild detergent.
Remove the cooling panel at the same time and soak it in a solution of water and mild
detergent.
Take out the tank and and rinse it under running water, removing any residue.
Let the filter, the panel and the tank dry completely after washing them; then re-fit the
components in the following order: water tank, cooling panel and dust filter.
Pannello Filtro
www.argoclima.com

Question & answers

There are no questions about the Argoclima Polifemo Class yet.

Ask a question about the Argoclima Polifemo Class

Have a question about the Argoclima Polifemo Class but cannot find the answer in the user manual? Perhaps the users of ManualsCat.com can help you answer your question. By filling in the form below, your question will appear below the manual of the Argoclima Polifemo Class. Please make sure that you describe your difficulty with the Argoclima Polifemo Class as precisely as you can. The more precies your question is, the higher the chances of quickly receiving an answer from another user. You will automatically be sent an e-mail to inform you when someone has reacted to your question.